Mopac Expressway, Austin, Texas 78759-3504, USA. LabVIEW™ is a trademark of National Instruments Corp., 11500 N. Liu, Derong, 1963629.8'9 ISBN-13: 9781848002142 Library of Congress Control Number: 2008927633 © 2008 Springer-Verlag London Limited MATLAB® and Simulink® are registered trademarks of The MathWorks, Inc., 3 Apple Hill Drive, Natick, MA 01760-2098, USA. Chinaĭerong Liu, PhD Department of Electrical and Computer Engineering University of Illinois at Chicago Chicago, IL 60607 USAĭOI 10.1007/978-1-84800-215-9 British Library Cataloguing in Publication Data Networked control systems : theory and applications 1. speed~ 3.Networked Control Systems Theory and Applicationsįei-Yue Wang, PhD Chinese Academy of Sciences Beijing 100080 P. We change it to 44 means it can support speed up to 4.4 Mbps. we can get maximum speed of 3.6 Mbps.For achieving this speed we need to tune the value of maxHsRate. Default value is 15 that will support 1.5Mbps.
The value of maxHsRate is related to the capacity of the AAL2 paths allocated to AAL2 connection of Class C in one Node B.
HSPA Parameters - NodeB maxHsRate maxHsRate is the maximum HSDPA bit rate possible over Iub i.e it determines the max possible HSDPA bit rate of HS flow over the Transport N/w. Value Range = 0 to 200 New value =2 (earlier it was set to 0) Value 2= 2*.1=.2dB It is relative to the maximum available power of the cell. It is possible to use the entire remaining carrier power for the HS-PDSCH and HS-SCCH, but if a more conservative power allocation is desired, this can be configured with the parameter hsPowerMargin, which acts as a back off from the maximum downlink transmission power of the cell.
HSPA Parameters - NodeB hsPowerMargin PHS = P max - P non-HS - hsPowerMargin, HS Power Margin total transmitted carrier power of all codes not used for HS the power available for the HS the maximum downlink transmission power for the cell signaled from the RNC. The maximum number of HS-PDSCH codes is dependent on license level and parameter maxNumHsPdschCodes up to 15 codes may be allocated. HSDPA_NON_CAPABLE - HSDPA Not supported.HSPA Parameters - NodeB maxNumHsPdschCodes hsdpaCapability This parameter is use to set the HSDPA capability of cell. List of HSPA Parameters - NodeB Following are the main parameter for Node-B which effect the data throughput in HS DATA Speed Check through NetPerSec Tool NetperSec Tool can be downloaded free-of-cost from Internet.
0 kommentar(er)
